For use with Rotary Converter
for 3-phase electronic equipment such as CNC/PLC machines, AC/DC
drives, and all voltage-sensitive equipment. Provides +/- 5% voltage
normal operating voltage of the Rotary Phase Converter is
208-230VAC on the 220V "R" series Rotary Converter, and 460VAC
on the 460V "RH" series Rotary Converter. The generated phase output voltage of the Rotary Phase Converter is
normally higher than the input voltage under no load and light
load conditions. In applications with high single-phase voltage
(greater than 230V on the 220V "R" series, and greater than 460V
on the 460V "RH" series), the no load or light load output voltage
may be excessive. Some CNC/PLC equipment will not work properly at
the higher output voltage.
Phase-A-Matic™ Voltage Stabilizer is designed to reduce this
higher voltage to nearer the input voltage. It will also keep
the output voltage stable during peak loads, thus helping CNC/PLC
equipment and other voltage-sensitive equipment to operate
very small motors alone on a Rotary Converter that is 3 times
more) may not reduce the output voltage sufficiently, in
which case the smaller motor may run hot. For these cases, to
reduce cost it may be possible to use a dedicated Voltage
Stabilizer sized to the requirements of the problem motor or
Supplied in a
NEMA type 1 enclosure with various sizes of knockouts.
for indoor use only in dry locations, but can be placed in a
rain tight enclosure for use in wet or damp locations.
a Voltage Stabilizer at least as large as the load it will
operate. It does not have to be as large as the Rotary Phase
Converter being used.